Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
962 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
1004 ABRT The port has been seized by a user for a valid call. Use status trunk to
determine when the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1005 ABRT Test failed due to incompatible configuration administered in trunk group
screen.
1. Look at the Trunk Group administration screen and see if the trunk is
incoming only, port 24 on a DS1 Interface with common
control-channel signaling, or an automatic CO type such as FX. Under
any of these conditions this is a normal abort.
1018 ABRT Test has been disabled via administration.
1. Verify that the Maintenance Tests field on the Trunk Group screen is
set to n. To enable the test, enter change trunk-group x where
x” equals the number of the trunk group to be tested, and change the
Maintenance Tests field on the screen to y.
2. Repeat the test.
1020 ABRT The DS1 Interface circuit pack is out-of-service.
1. Look for UDS1-BD errors in the Hardware Error Log. If present, see
UDS1-BD (UDS1 Interface Circuit Pack)
on page 2374.
2. Retry the command.
2000 ABRT Response to the test request was not received within the allowable time
period.
1. Rerun the test at 1-minute intervals up to 5 times.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Table 331: Test #314 DS1 CO Dial Tone Seizure Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 3