Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
852 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Looparound and Conference Circuit Test (#33)
Note:
Note: S8300 / G700: This test aborts with Error Code 1412.
This test checks the reflective loop-around and conference capabilities of a CO port circuit. The
test uses 404-Hz, 1004-Hz, and 2804-Hz tones. Each tone is transmitted separately through
the loop and checked.
Table 291: Test #33 Looparound and Conference Circuit Test
Error
Code
Test
Result
Description / Recommendation
ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
7 ABRT Conference Circuit test aborted.
1. Retry the command at 1-minute intervals up to 5 times.
129 ABRT The 404-Hz reflective loop-around test aborted. Response to the test
request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
131 The 1004-Hz reflective loop-around test aborted. Response to the test
request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
133 The 2804-Hz reflective loop-around test aborted. Response to the test
request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABRT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Use display port location to determine the trunk group/
member number of the port. Use status trunk to determine the
service state of the port. If the port is active, wait until it is idle before
testing.
2. If the port status is active but the port is idle (no calls), check the error
log for error type 769 (see the error log table for a description of this
error and required actions). The port may be locked up.
3. If the port status is idle, retry the command at 1-minute intervals up to
5 times.
1 of 4