Filter
Top Products
ATM-TRK (Circuit Emulation Service Circuit Pack)
Issue 1 June 2005 637
ATM Board Error Query Test (#1259)
This nondestructive ATM Error Query test retrieves the most severe, active, on- and off-board
problem from the ATM-TRK circuit pack’s firmware and increments error counts in the Error Log.
The test passes if there are no errors and fails otherwise. A passing test clears the software
counters; a failure increments the counter associated with the problem that caused the failure
and clears the others.
Table 215: ATM Board Error Query Test (#1259)
Error
Code
Test
Result
Description / Recommendation
2000 ABRT Test request timed out.
2031 ABRT SCD failure. Unable to send down-link message.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABRT Could not allocate needed system resources.
1. Retry the command at 1-minute intervals up to 5 times.
2500 ABRT Internal system error
1. Retry the command up to 3 times at 1-minute intervals.
XXYY FAIL On-board error XX (Table 216: Aux Data XXfor ATM Board Error Query
Test (#1259) on page 638) and/or off-board error YY (Table 217: Aux Data
YY for ATM Board Error Query Test (#1259) on page 638).
1. Examine the error logs and repair any errors found.
PASS The ATM circuit pack has passed this test. No service effecting errors/
alarms have been detected on board.
0
NO
BOARD
ATM-TRK circuit pack not found
1. Check the error log, and correct Error 125 (wrong board) or Error 131
(no board), if found.
2. Make sure that the board is properly translated and inserted.
3. Check for hyperactivity (Error 1538). Run reset board location if
hyperactive.
4. Run the test again. If it fails, replace the board, and retest.