Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
854 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
7 FAIL The conference capabilities of the port failed (Error Code 7).
129 The reflective 404-Hz Tone test failed. No transmission was detected to or
from the port (Error Code 129).
FAULT ISOLATION: Proceed as follows unless power or tone problems are
suspected (see Description/Recommendation for Error Code 7 below).
2. To make sure the problem is on-board, disconnect the port from the
CO and retry the test. Coordinate this with the CO, or do it after busy
hours; otherwise, the CO may put the connection out of service.
3. If the retry fails, replace the circuit pack.
4. If the retry passes and no troubles have been reported, disable the
test. If the retry passes and troubles have been reported, refer the
problem to the CO.
131 The reflective 1004-Hz Tone test failed. No transmission was detected to
or from the port (Error Code 131).
FAULT ISOLATION: Proceed as follows unless power or tone problems are
suspected (see Description/Recommendation for Error Code 7 below).
5. To make sure the problem is on-board, disconnect the port from the
CO and retry the test. Coordinate this with the CO, or do it after busy
hours; otherwise, the CO may put the connection out of service.
6. If the retry fails, replace the circuit pack.
7. If the retry passes and no troubles have been reported, disable the
test. If the retry passes and troubles have been reported, refer the
problem to the CO.
133 The reflective 2804-Hz Tone test failed. No transmission was detected to
or from the port (Error Code 133).
FAULT ISOLATION: Proceed as follows unless power or tone problems are
suspected (see Description/Recommendation for Error Code 7 below).
8. To make sure the problem is on-board, disconnect the port from the
CO and retry the test. Coordinate this with the CO, or do it after busy
hours; otherwise, the CO may put the connection out of service.
9. If the retry fails, replace the circuit pack.
10. If the retry passes and no troubles have been reported, disable the
test. If the retry passes and troubles have been reported, refer the
problem to the CO.
Table 291: Test #33 Looparound and Conference Circuit Test (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 4