Filter
Top Products
ANL-LINE (8-Port Analog Line)
Issue 1 June 2005 411
Battery Feed Test (or Port Diagnostic Test) (#35)
The battery feed chip provides power to the telephone equipment, signaling, rotary dial pulsing,
transmission, and balance. This test checks the signaling and switchhook capabilities of the
battery feed chip by terminating the port, applying battery, and trying to detect a current.
Table 121: Test #35 Battery Feed Test Results
Error
Code
Test
Result
Description / Recommendation
ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABRT System resources required to run this test are not available. The port may
be busy with a valid call. This result is also reported for the system’s
Music-on-Hold port when it is off-hook, which it usually is.
1. Enter display port location to determine the station’s extension.
Enter status station extension to determine the service state of
the port. Refer to Maintenance SAT Commands
in the Maintenance
Commands Reference (03-300191), for a full description of every
possible state. If the port is active, it will be unavailable for certain
tests. Wait until the port is idle before retesting.
2. When the port is idle, retry the command at 1-minute intervals up to 5
times.
1004 ABRT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Use display port location to determine the station extension.
Use status station to determine the service state of the port. If the
service state indicates that the port is active, then the port is
unavailable for certain tests. Refer to Maintenance SAT Commands
in
the Maintenance Commands Reference (03-300191), for a full
description of every possible state. Wait until the port is idle before
retesting.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort and the port is idle, escalate the problem.
1 of 3