Filter
Top Products
SNMP Alarming on the G700
Issue 1 June 2005 303
To configure an SNMP community string for traps
1. Open the Run dialog box.
2. Type telnet <IP address of L2 Processor> and press Enter.
3. Log in as root.
4. At the L2 Processor CLI prompt, type set snmp community trap [community
string] and press Enter.
5. Type exit
Configure the destination for G700 SNMP traps
Events occurring on the G700 cause SNMP traps to be generated. The G700 MGP can be
configured to send SNMP traps to any network management system (NMS) in the network,
including the primary server (S8300/S8700). The MGP CLI set snmp trap command is the
way to configure the NMS network element that will receive those traps. The traps are sent in
User Datagram Protocol (UDP) on the customer’s IP network.
The command syntax is:
set SNMP trap <IP address> {enable|disable}
[{all|power|temp|app|module|config|voice|operations}]
where <IP address> is the IP address of the NMS trap receiver that will be receiving the
traps from the G700, and
[{all|power|temp|app|module|config|voice|operations}] indicates the groups
whose traps will be sent to the specified receiver. If no keywords follow the IP address entry,
then all traps will be enabled for the specified receiver.
If "enable" or "disable" is used without a trap designation keyword, then all traps is
assumed. Up to ten trap receivers can be configured.
To configure the destination for G700 SNMP traps
1. From the L2 Processor CLI, type session mgp
2. At the mg-xxx-n(super-user) prompt, type configure and press Enter.
3. At the mg-xxx-n(configure) prompt, type set snmp trap <IP address> enable and
press Enter.
4. Type exit