Filter
Top Products
S8300 Media Server LEDs
Issue 1 June 2005 283
Figure 13: S8500 rear panel
S8300 Media Server LEDs
Figure 14: S8300 Media Server
The S8300 Media Server has a total of 6 LEDs on the faceplate (Figure 14: S8300 Media
Server on page 283). The three standard, red, green, and yellow LEDs. See S8300 LED
differences from Media Modules on page 284 for a detailed description of these LEDs.
The three additional LEDs:
● A fourth LED labeled “OK-to-Remove”, which indicates when the S8300’s disk is properly
shut down.
● Fifth and sixth LEDs, located on the lower left and right sides, respectively, of the
Services Port, which indicate whether or not data is being sent over the RJ45 jack, and
the data rate.
Figure notes:
1.
Activity
2.
Connection speed
● LED is off: there is a 10 BASE-T active link.
● LED is green: there is a 100 BASE-T active link.
● LED is orange: there is a 1000 BASE-T active link.
1
2
LINKTX/RX LINKTX/RX
PCI
1
PCI 2
100-127 -, 3,0A, 50/60 Hz
200-240 -, 1,5A, 50/60 Hz
133 MHz/64 Bit, 100 MHz/64 Bit
h3msble2 KLC 082503
100-127 -, 3,0A,
200-240 -, 1,5A, 5
1
2