Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
2552 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
SAKI Sanity Test (#53)
This test is destructive.
This test resets the circuit pack or media module. It is executed as part of the long test
sequence only for the Tone-Clock circuit pack and DS1 interface circuit packs, and for the
MM710 DS1 Interface Media Module. Other common circuit packs and media modules can be
reset with the reset board location command which also executes this test.
Table 912: Test #53 SAKI Sanity Test
Error
Code
Test
Result
Description / Recommendation
None ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1005 ABRT
S8700 | 8710 / S8500:
Wrong circuit pack configuration to run this test. This error applies only to
DS1 interface circuit packs. It means the DS1 interface circuit pack is
providing timing for the system and, therefore, it cannot be reset without
major system disruptions.
1. If the circuit pack needs to be reset, then set synchronization to
another DS1 interface circuit pack or the Tone-Clock circuit pack and
try again. See SYNC (Port-Network Synchronization)
on page 2143.
G700:
If this is a G700 media gateway system, and the MM710 DS1 interface
Media Module under test is providing timing for the platform, it cannot be
reset without major platform disruptions
Note: For this type of system the sync timing source is local to the G700.
1. If the MM710 Media Module needs to be reset, then set the
synchronization timing source to another MM710 DS1 interface Media
Module located in the same G700 and retest. See Setting G700
synchronization in Maintenance Procedures (03-300192).
1015 ABRT Port is not out-of-service.
1. Busy out the circuit pack or media module.
2. Execute command again.
2100 ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1 FAIL The circuit pack or media module failed to reset.
1 of 2