Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
1464 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
1113 FAIL The signaling link has failed; the system cannot send any messages on
behalf of this trunk.
1. Consult procedures for ISDN-SGR (ISDN-PRI Signaling Group) and
ISDN-LNK (ISDN Signaling Link Port).
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS Wait 4 minutes and then check the Error Log for any new errors of type
3073. If there are none, then both sides of the ISDN connection agree on
the service state; the negotiation succeeded. If there is a new 3073 error,
then the negotiation failed (the far-end switch twice failed to respond within
2 minutes). The switch will automatically retry every 15 minutes. If the trunk
was initially in service, it is now placed in the maintenance/far-end state.
Incoming calls will be accepted, but no outgoing calls can be originated. If
an incoming call is presented, another Service State Audit will be
immediately performed in an attempt to put the DS1 ISDN Trunk in the
proper state.
Any
NO
BOARD
The test could not relate the internal ID to the port (no board). This could be
due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute add ds1
location to administer the MM710 interface if it is not already
administered.
If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the board is
shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then enter
busyout board location.
Enter reset board location.
Enter release board location.
Enter test board location long.
This should re-establish the linkage between the internal ID and the port.
Table 528: Test #256 Service State Audit Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2