Filter
Top Products
ATM-TRK (Circuit Emulation Service Circuit Pack)
Issue 1 June 2005 643
5 FAIL Unable to create packet-path loop.
1. Retry the command up to 3 times at 1-minute intervals.
2. If this test continues to fail, replace the ATM-TRK circuit pack.
3. Rerun test board location long.
6 FAIL A previously established loop around was not released.
1. Run reset board location.
2. Retry the command up to 3 times at 1-minute intervals.
3. If this test continues to fail, replace the ATM-TRK circuit pack.
4. Rerun test board location long.
PASS The non-optical parts of the ATM-TRK circuit pack are functioning properly.
0
NO
BOARD
ATM-TRK circuit pack not found
1. Check the error log for Error 125 (wrong board) or Error 131 (no board),
and correct as necessary.
2. Check that the board is properly translated and inserted.
3. Check for Error 1538 (hyperactivity), and run reset board
location if necessary.
4. Rerun test board location long.
5. If the test fails, replace the board, and rerun test board location
long.
Table 218: ATM Board Framer Loop-Around Test (#1260) (continued)
Error
Code
Test
Result
Description / Recommendation
4 of 4