Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
404 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
ANL-LINE (8-Port Analog Line)
Error log entries and tests also apply to ANL-NE-L (8-Port Analog Line).
S8700 | 8710 / S8500
The 8-port Analog Line circuit packs,
each provide eight ports for single-line, on or off-premises analog endpoints such as analog
voice terminals, queue warning level lamps, recorded announcements, dictation machines,
PAGEPAC paging equipment, external alerting devices, modems, fax machines, and AUDIX
voice ports. Only the TN769 supports a neon message waiting lamp.
Note:
Note: PAGEPAC™ is a registered trademark of Harris Corporation, Dracon Division.
Test #48 may cause some terminal equipment to ring briefly during daily maintenance, which
may disturb the customer or the terminal equipment. Test #47 may cause a false alarm when
the port is connected to certain off-premises equipment, non-voice terminal equipment, or loop
equipment. In either case, the tests can be disabled by entering n in the Tests field on the
change station extension screen. Be aware that this will disable Tests 6, 35, 47, and 48.
No maintenance of the terminal connected to the 8-Port Analog Line circuit pack or 8-Port Neon
Analog Line circuit pack is performed, except to determine whether or not the terminal is
connected. Failures of the common ringing application circuitry and the neon message waiting
lamp power (ANL-NE-L only) are reported as errors 1281and 1793 against XXX-BD (Common
Port Circuit Pack) in Table 907: Common Port Circuit Pack Maintenance Error Log Entries
on
page 2544.
MO Name in Alarm
Log
Alarm
Level
Initial Command To Run Full Name of MO
ANL-LINE MIN test port location l 8-Port Analog Line
ANL-LINE WRN test port location sh 8-Port Analog Line
ANL-NE-L MIN test port location l 8-Port Neon Analog Line
ANL-NE-L WRN test port location sh 8-Port Neon Analog Line
TN712 TN411 [G3rV2] TN742
TN443 [G3r V2] TN769
TN443 [G3r V2] TN467 [G3r V2]