Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
1428 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Table 513: Test #939 Signaling Port LAN Loop back
Error
Code
Test
Result
Description / Recommendation
1015 ABRT The port is not in the out-of-service state. Use busyout port location
to place it in the out-of-service state and repeat this test.
!
CAUTION:
CAUTION: The busyout prevents new call originations on every B
channel in the signaling group until the port is released.
1139 ABRT This port network’s packet bus is out of service.
1. Follow repair procedures for the packet bus.
2. Enter test port location long, and check results of this test
(#939).
1141 ABRT The Packet Interface circuit pack is out of service.
3. Follow repair procedures for PKT-INT.
4. Enter test port location long, and check results of this test
(#939).
S8300 /
G700:
1412
ABRT This test does not execute on a G700 media gateway.
2012 ABRT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The Loop-Back Test has failed.
1. If the test fails repeatedly, attempt to reset the circuit pack when the
other ports on the board are idle. Reset the circuit pack by entering
busyout board location and reset board location.
2. Repeat the test and, if it continues to fail, replace the circuit pack.
PASS Connectivity of the D channel over the packet bus is operational.