Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
1820 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
NO
BOARD
The IPSI circuit pack’s Packet Interface module is assigned, but is not
detected as being physically present.
1. If the IPSI circuit pack is present, replace it.
2. If the IPSI circuit pack is not present, insert a TN2312AP IPSI circuit
pack in the assigned slot, and run the test again.
1 FAIL The Boot PROM memory checksum test failed. The circuit pack may still
be operational.
1. This may be the result of old firmware not supporting new software
operation. Verify the IPSI circuit pack’s firmware vintage and download
the new firmware if appropriate.
2. The firmware image on the IPSI circuit pack may have been corrupted.
Download the firmware image.
3. Retry the command.
4. The same Error Code occurs:
a. If this is a standard- or duplex-reliability system, replace the circuit
pack at a time that would cause the least disruption of service. The
circuit pack is still functional but should be replaced since it may not
operate after a system reboot and it will enter a fatal fault state if it is
reset for other reasons.
b. If the Packet Interface module is on the standby IPSI (
S8700 MC: and
this is a high- or critical-reliability system), replace that circuit pack.
c. If the Packet Interface module is on the active IPSI (
S8700 MC: and
this is a high- or critical-reliability system), use set
ipserver-interface to perform a planned IPSI interchange.
Table 669: Test #884 Memory Checksum Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 3