Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
408 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
1003 ABRT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present or some Tone
Detectors may be out-of-service.
1. Resolve TTR-LEV errors.
2. Resolve TONE-PT errors.
3. Retry the test at 1-minute intervals up to 5 times.
1004 ABRT The port was seized by a valid call during the test. The test has been
aborted.
1. Use display port location to determine the station extension.
Use status station to determine the service state of the port. If the
service state indicates that the port is active, then the port is
unavailable for certain tests. Wait until the port is idle before retesting.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort and the port is idle, escalate the problem.
1005 ABRT The test was aborted due to a configuration problem. This code occurs
under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, a modem pool
member or music on hold).
2. The circuit pack is one of the following:
- TN742 vintage 13, 14, or 15
- TN769 vintage 3, 4, or 5
1018 ABRT Test disabled by administration. The default for the Test field on the station
screen is y; thus, you may want to determine why this field has been set to
n on this station (this may be due to the ringing application test 48, which
can be customer or terminal disturbing).
1. To enable the test for a particular station, enter change station
extension and set the Test field to y.
1020 ABRT The test did not run due to a previously existing error on the specific port or
a more general circuit pack error.
1. Examine Error Log for existing errors against this port or the circuit
pack and attempt to diagnose the previously existing error.
Table 120: Test #6 NPE Crosstalk Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 4