Communication Manager Maintenance-Object Repair Procedures
692 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
This test is not executed for ABRI-PORT/ATT-PORT/LGATE-PT/ATTE-PT because the B
channels associated with the port are not used by ASAI or Avaya adjuncts.
Table 231: Test #617 NPE Crosstalk Test
Error
Code
Test
Result
Description / Recommendation
1000 ABRT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Use display port location to determine the station extension or
trunk group/member number of the port. Use status bri-port
location to determine the service state of the port. If the service
state indicates that the port is active, then the port is unavailable for
certain tests. (Refer to Maintenance SAT Commands
in Maintenance
Commands Reference (03-300191) for a full description of every
possible state.) Wait until the port is idle before retesting.
2. If the port status is idle, then retry the command at 1-minute intervals up
to 5 times.
3. If the test continues to abort, escalate the problem.
1004 ABRT The port has been seized by a user for a valid call.
1. Use status station for the station associated with this port and
determine when the port is available for testing.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort and the port is idle, escalate the problem.
1005 ABRT This test is not valid for this type of translation. Ports administered as “ASAI”
or “ADJK” cannot run this test, because the B channels associated with the
port are not used by ASAI or Avaya Adjunct Links. This is a normal
condition.
2012 ABRT Internal system error.
2100 ABRT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1, 2 FAIL The NPE of the tested port was found to be transmitting in error. This
causes noisy and unreliable connections. Error code 1 indicates that the
NPE Crosstalk test failed on Channel B1. Error code 2 indicates that the
NPE Crosstalk test failed on Channel B1.
1. Replace the circuit pack.
1 of 2