STA-FWDL
Issue 1 June 2005 2127
3 ABRT The terminal was not downloaded before the scheduled stop time
occurred. Schedule a new download with adequate time for the
downloads to complete, or select the continue daily option to allow the
schedule to resume the following day.
4 ABRT The terminal could not be downloaded because the schedule aborted for
an unknown reason.
5 ABRT The terminal did not respond to the download request.
6 ABRT The terminal that was added to the download list at the scheduled start
time no longer exists. This can occur when a station is removed during an
active download schedule. Download to this terminal was aborted.
18 ABRT The terminal was busied out by craft and could not be downloaded.
32 ABRT Download to the terminal timed out due to an internal error in the station
firmware download process.
1000 ABRT Terminal was in use at the time that it was to be downloaded. Download to
this terminal was aborted.
1012 ABRT An internal error occurred while preparing to download to this station.
3841 ABRT
or
FAIL
The system restarted during an active download. As a result, all terminals
that were not downloaded are marked with a status of ABRT with this
reason code. All terminals that were actively downloading when the reset
occurred are marked with a status of FAIL with this reason code.
128 FAIL The terminal rejected the firmware because the firmware image failed the
checksum test.
129 FAIL The terminal rejected the firmware because the firmware image failed the
image validity test. The firmware image may not be the right image for the
hardware being downloaded to.
130 FAIL The terminal being downloaded could not write its flash memory.
131 FAIL The translated terminal type is valid, however the actual terminal type of
the hardware is not valid for this download schedule.
513 FAIL The terminal was not in service at the time that it was to be downloaded.
Download to this terminal failed.
3584 FAIL The terminal rejected the firmware image.
Table 762: Reason Codes for status firmware station-download command (continued)
Reason
Code
Status Description
2 of 2