Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
ATM-EI (Expansion Interface Circuit Pack)
Issue 1 June 2005 555
Packet Interface Test (#598)
This test is nondestructive and attempts to send a data packet from the TN1655 Packet
Interface circuit pack through any ATM PNC Expansion Interface circuit packs. The path the
data packet takes depends on the location of the ATM PNC Expansion Interface circuit pack
being tested and whether the system has duplicated port-network connectivity.
FAIL A PN’s unduplicated ATM-EI circuit pack responded incorrectly, or a PN’s
active ATM-EI circuit pack could not communicate with the PN’s circuit
packs.
1. If the PN’s active ATM-EI circuit pack is failing and duplicated PNC is
enabled:
a. Enter reset PNC interchange to switch to the standby PNC.
b. Repeat the short test sequence.
c. If test continues to fail, enter reset board location to reset the
ATM-EI circuit pack.
2. If the PN’s unduplicated ATM-EI circuit pack is failing:
a. Enter display errors and display alarms, and follow the
associated repair procedures for TDM-CLK, TONE-BD, or SYNC
alarms/errors.
b. Repeat the short test sequence.
c. If test continues to fail, replace the circuit pack or transceiver.
PASS The ATM-EI circuit pack did respond correctly to test. Communication from
software to the ATM-EI circuit pack is functioning.
1. Refer to other ATM-EI circuit pack tests if the link is not functioning
correctly.
0
NO
BOARD
No board was detected by the test.
1. Resolve any wrong board (Error 125) or no board (Error 131) issues.
2. Check that the board is properly translated and inserted. If so, check
for hyperactivity (Error 1538). If hyperactive, use reset board
location.
3. Run the test again. If it fails, the NCE chip on board could be bad.
Replace the board and retest.
Table 176: Expansion Interface Control Channel Test #316 (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2