Filter
Top Products
EXP-INTF (Expansion Interface Circuit Pack)
Issue 1 June 2005 1207
1003 ABRT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of tone detectors present or some
tone detectors may be out of service.
1. Enter display errors and follow the repair procedures for
TTR-LEV errors in the error log. Even if there are not TTR-LEV
errors, there may not be a tone detector available on the network
that contains the circuit pack being tested. Verify that there is at
least one tone detector on this network. If not, this test will always
abort for this EI circuit pack. This will not harm the system in any
way.
S8700 MC: Tone Detector circuit packs (TN768) must be of vintage
“B” or newer. If older Tone Detector circuit packs are installed in
the system, this test will always abort with this code.
2. Enter display errors and follow the repair procedures for
TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals
up to 3 times.
1033 ABRT The test cannot run because either the EI board does not have a fiber
link administered to it and there is not sufficient data to run the test, or
there were no other PNs administered that had its EI board
In-Service.
1. Check fiber administration to insure that there is a fiber link
administered to this EI circuit pack.
2. If there is a fiber administered to this EI circuit pack, then some
change in the status of the ability of the EI circuit pack in the other
PNs to communicate with the EI or SNI circuit pack on the other
end of its fiber has occurred.
3. Test #237 and check for EXP-INTF circuit pack Error Type 1281 in
the Error Log for the EI circuit packs in these other PNs. If Error
Type 1281 is present and/or Test #237 does not pass, see repair
procedures for Test #237, in Table 409: Test #237 Expansion
Interface Neighbor Query Test on page 1199.
4. If Test #237 passes, reseat the EI circuit pack. This is not
destructive since the circuit pack cannot be serving as the
Expansion Archangel if it is not in service.
Table 412: Test #241 Expansion Interface 2-Way Transmission Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 5