Filter
Top Products
E-DIG-STA (Emulated Digital Line)
Issue 1 June 2005 1125
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 18: Maintenance personnel have busied out the port in question. Make sure that
the port is released from busyout by using release port location.
c. Error Type 130: The circuit pack has been removed or has been insane for more than
21 minutes. To clear the error, reinsert or replace the circuit pack.
d. Error Type 257: Problems transmitting to the voice terminal. This problem can be caused
by defective wiring that can cause varying degrees of problems on different types of sets.
Sets such as the 7410 appear to be more susceptible to wiring problems than others.
e. Error Type 1537: An in-link maintenance error has generated an off-board warning due to
some problem with the link to the voice terminal. This can be ignored if no user complaints
are received. Otherwise, make sure the voice terminal is connected, check for defective
wiring, check for a defective voice terminal, and move voice terminal to a jack that is closer
to the switch (number of feet of wiring between the jack and the switch). If the problem still
exists, replace the circuit pack. Once the problem has been resolved, the alarm is retired
after a predetermined amount of time.
f. Error Type 1793: The local loop test failed. Each failure increments the counter by 1 when
the local loop test fails. The counter is decremented when the loop test passes. When the
counter reaches a threshold of 3, an on-board MINOR alarm is raised.
g. Error Type 2049: The NPE Crosstalk test failed. The counter increments by 1 when the
NPE Crosstalk test fails. The counter is decremented by 1 when the NPE Crosstalk test
passes. When the counter reaches a threshold of 3, an on-board MINOR alarm is raised
and the board is taken out of service.
2049 (g
) NPE Crosstalk
test (#9)
MIN
WRN
1
ON test port location l r 3
2305 (h
) 32770 None
3840 (i
) 40965 None
3841 (j
) 41029 None
2304 (k
)None
1. Major alarms may be downgraded to Warning alarms based on the value used in set options.
Table 382: Digital Line Error Log Entries – E-DIG-STA (continued)
Error
Type
Aux
Data
Associated
Test
Alarm
Level
On/Off
Board
Test to Clear Value
2 of 2