Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
2004 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
7. Wait 5 minutes for SNI-BD, SNI-PEER, FIBER-LK, and DS1C alarms to clear, or enter
clear firmware-counters a-pnc | b-pnc. Use the letter designation of the PNC
that holds the replaced component (the standby PNC).
8. Enter status pnc.
If either PNC’s state of health is not “functional”, consult PNC-DUP (PNC Duplication)
on
page 1851.
9. Enter release pnc.
Error Log Entries and Test to Clear Values
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 1: indicates SNC on-board microcontroller error. (This occurs when the
microcontroller sanity test fails, the ROM has problems, the processor internal or external
RAM is faulty, or the firmware instruction test fails. In addition, this error indicates problems
with the interrupt capabilities, the dual-port RAM and the RTM (real-time monitor) interface
on the faceplate of the SNC.)
1. Replace the SNC circuit pack.
Table 738: SNC Board Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Test to Clear Value
0 (a
)
0 Any Any Any test board location r 1
1 (b
)
Any Failure audit (#777) MAJ ON test board location r 1
18 (c
)
0 busyout board location WRN OFF release board location
257 (d
)
Any Failure audit (#777) MAJ OFF test board location r 1
513 (e
)
Any Failure audit (#777) MIN OFF test board location r 1
769 (f
)
Any Failure audit (#777) MIN OFF test board location r 1
1025 (g
)
Any Failure audit (#777) MAJ ON test board location r 1
1281 (h
)
Any Failure audit (#777) MIN OFF test board location r 1
1537 (i
)
Any Failure audit (#777) MIN ON test board location r 1
1793 (j
)
Any Failure audit (#777) MAJ ON test board location r 1
2049 (k
)
Any Failure audit (#777) MAJ ON test board location r 1