Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
2210 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Table 788: Test #617 BRI NPE Crosstalk Test
Error
Code
Test
Result
Description / Recommendation
1000 ABRT System resources required to run this test are not available. The
port may be busy with a valid call.
1. Use display port location to determine the station
extension or trunk group/member number of the port. Use
status bri-port location to determine the service state
of the port. If the service state indicates that the port is in use,
then the port is unavailable for certain tests. Wait until the port is
idle before retesting.
2. If the port status is idle, then retry the command at 1-minute
intervals up to 5 times.
1004 ABRT The port has been seized by a user for a valid call. Use status
bri-port location to determine when the port is available for
testing.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort and the port is idle, escalate the
problem.
1005 ABRT This test is not valid for this type of translation. Ports administered as
“ASAI” or “ADJK” cannot run this test, because the B channels
associated with the port are not used by ASAI or Avaya Adjunct
Links. This is a normal condition.
S8300 / G700:
1412
ABRT This test does not execute on a G700 media gateway.
2012 ABRT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1, 2 FAIL The NPE of the tested port was found to be transmitting in error,
causing noisy and unreliable connections. Error code 1 indicates
that the BRI NPE Crosstalk test failed on Channel B1. Error code 2
indicates that the BRI NPE Crosstalk test failed on Channel B2.
1. Replace circuit pack.
1 of 2