Filter
Top Products
M/T-DIG (Maintenance/Test Digital Port)
Issue 1 June 2005 1713
Table 633: Test #9 NPE Crosstalk Test
Error
Code
Test
Result
Description / Recommendation
1000 ABRT System resources required to run this test are not available. The port may
be in use on a valid ISDN-PRI test call. Use list isdn-testcall to
determine whether the port is in use (listed in the M/T Port column). If so,
wait for the test call to finish as indicated in the Start Time and Duration
fields, or abort the test call with clear isdn-testcall grp#/mem#,
where grp#/mem# is determined from the B-channel field of list
isdn-testcall.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort and the port is idle, escalate the problem.
1001 ABRT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1002 ABRT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out of service due
to TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
repeat test at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1003 ABRT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of tone detectors present or some tone
detectors may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals up to 5
times.
4. If the test continues to abort, escalate the problem.
1 of 2