Filter
Top Products
ANL-16-L (16-Port Analog Line)
Issue 1 June 2005 399
Loop-Around Test (#161)
This test checks the on-board transmission capabilities of the NPE, the codec, and the battery
feed chip of the analog port. The test passes if the signal measured by the Tone Detector is
within acceptable limits.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This could
be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Verify that the board’s translations are correct. Enter list config,
and resolve any problems.
2. If the board was found to be correctly inserted in step 1, enter
busyout board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location long
This should re-establish the linkage between the internal ID and the port. If
not, verify that a valid board is inserted.
Table 117: Test #48 Station Present Test (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 3
Table 118: Test #161 Loop-Around Test
Error
Code
Test
Result
Description / Recommendation
ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABRT System resources required to run this test are not available. The port
may be busy with a valid call.
1. Use display port location to determine the station extension.
2. Use status station to determine the service state of the port. If
the port is active, wait until it is idle.
3. Retry the command at 1-minute intervals up to 5 times.
1 of 4