Filter
Top Products
ISDN-SGR (ISDN-PRI Signaling Group)
Issue 1 June 2005 1445
Any
NO
BOARD
The test could not relate the internal ID to the port (no board). This could be
due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute add ds1 location
to administer the circuit pack or media module interface if it is not already
administered.
If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the board is
shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then enter busyout
board location.
Enter reset board location.
Enter release location board.
Enter test board location long.
This should re-establish the linkage between the internal ID and the port.
Table 519: Test #647 Layer 2 Status Query Test (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 3