Filter
Top Products
IPMEDPRO (TN2602AP IP Media Resource 320)
Issue 1 June 2005 1387
SAKI Sanity Test (#53)
This test is destructive.
This test is only run as a part of a reset board procedure. For the Media Resource, use the
change ip-interface screen to disable the Media Resource’s IP interface before
performing this procedure.
A reset of this circuit pack takes about 3½ minutes.
FAIL The circuit pack failed to return the circuit pack code or vintage.
1. Retry the command up to 5 times.
2. If the problem continues, replace the circuit pack.
3. Retry the command up to 5 times.
PASS Communication with this circuit pack is successful.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This could
be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Administer the IP Media
Resource interface if it is not already administered.
2. If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the
board is shut down. Reseat the board to reinitialize it.
3. If the board was found to be correctly inserted in step 1, enter
busyout board location.
4. Enter reset board location.
5. Enter release board location.
6. Enter test board location long.
This should re-establish the linkage between the internal ID and the port.
Table 487: Test #52 Control Channel Loop-around Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2