Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
2214 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Table 790: Test #619 BRI Port Local TDM Loop Around
Error
Code
Test
Result
Description / Recommendation
1000 ABRT The system resources required to run this test are not available. The
port may be busy with a valid call.
1. Use display port location to determine the trunk group/
member number of the port. Use status bri-port
location to determine the service state of the port. If the
service state indicates that the port is in use, the port is
unavailable for certain tests. Wait until the port is idle before
retesting.
2. If the port is idle, retry the command at 1-minute intervals up to 5
times.
1002 ABRT The system could not allocate time slots for the test. The system
may be under heavy traffic conditions or it may have time slots
out-of-service due to TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy
traffic, repeat test at 1-minute intervals up to 5 times.
1003 ABRT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors present
or some Tone Detectors may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals up
to 5 times.
1004 ABRT The port has been seized by a user for a valid call. Use status
trunk for the trunks associated with this port and determine when
the port is available for testing.
4. Retry the command at 1-minute intervals up to 5 times.
5. If the test continues to abort and the port is idle, escalate the
problem.
1005 ABRT This test is not valid for this type of translation. Ports administered as
ASAI or ADJK cannot run this test because the B channels
associated with the port are not used by ASAI or Avaya Adjunct Links.
This is a normal condition.
S8300 / G700:
1412
ABRT This test does not execute on a G700 media gateway.
1 of 2