Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
1266 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
2306 ABRT An SNI circuit pack on the fiber link is not responding to test requests sent
by software.
1. Run the test led switch-node for the switch node(s) where the
SNI(s) reside to verify whether the LEDs on the board(s) light. Follow
the steps below for the SNI(s) that had no LEDs light.
2. If the LEDs on the other boards in the carrier light, but the LEDs on this
board do not light, run Test #760 via test board location l for
the active SNC in this carrier. Wait 5 minutes and then try step 1 one
more time. If the LEDs on this board still do not light, replace the
board. (Replacing an SNI may be service interrupting. Refer to the
SNI-BD section for the procedure to replace an SNI.)
3. If none of the LEDs light for the boards in the same carrier as this
board, fix any problems associated with the connectivity of this carrier
to the media server. Use list fiber-link to determine the fiber
connections to this carrier. Check the LEDs on every SNI and EI, and
fix any fiber problems. Enter display errors and resolve any
EXP-INTF error entries associated with the PN. Also, resolve any
SYNC, SNI-BD, SNC-BD, FIBER-LK, or SNI-PEER error entries.
2500 ABRT Internal system error If this fiber link has two SNI endpoints, run test
board location separately for each SNI and follow the repair
procedures in section SNI-BD. Use list fiber-link to see a fiber
link’s endpoints. Otherwise:
1. Retry the command at 1-minute intervals up to 3 times.
102 FAIL The SNI circuit pack (Endpoint 1) cannot communicate with the equipped
SNI in slot 2. Use list fiber-link to see a fiber link’s endpoints.
1. Perform the Fiber link fault isolation
in Chapter 4: General
troubleshooting in Maintenance Procedures (03-300192). This should
resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER Error Type 1, replace the SNI
being tested. (Replacing an SNI may be service interrupting. Refer to
the SNI-BD section for the procedure to replace an SNI.) To view
SNI-PEER errors, use display errors with category PNC-PEER.
Retry the command.
3. If the SNI being tested still has SNI-PEER Error Type 1, replace the
SNI in slot 2.
Table 440: Test #759 Configuration Audit (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 22