Filter
Top Products
AN-LN-PT (Analog Line Port)
Issue 1 June 2005 443
Analog Looparound Test (#161)
S8300 / G700: This test aborts with Error Code 1412.
This test checks the on-board transmission capabilities of the NPE, the codec, and the battery
feed chip of the analog port. The test passes if the signal measured by the Tone Detector is
within acceptable limits.
Table 131: Test #161 Analog Looparound Test
Error
Code
Test
Result
Description / Recommendation
ABRT Necessary system resources could not be allocated to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1000 ABRT System resources are unavailable. The port may be busy with a valid call.
This result is also reported for the system’s Music-On-Hold port when it is
off-hook, which it usually is.
1. Enter display port location to determine the station’s extension.
2. Enter status station extension to determine the service state of
the port.
3. If the port is active, wait until it is idle. Retry the command at 1-minute
intervals up to 5 times.
4. If the test continues to abort, escalate the problem.
1002 ABRT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or have time slots out-of-service due to
TDM-BUS errors.
1. Refer to “TDM-BUS” to diagnose any active TDM-BUS errors.
2. If the system has no TDM-BUS errors and is not handling heavy traffic,
retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort, escalate the problem.
1 of 4