Filter
Top Products
ANNOUNCE (announce)
Issue 1 June 2005 477
ANNOUNCE (announce)
● The ANNOUNCE MO logs an error in the hardware error log if save announcements or
restore announcements does not complete successfully, or the system fails to restore
announcements from the memory card at boot time.
Figure 23: Connection of announcement circuit pack to the system
on page 477 shows the
connection of the Announcement Circuit Pack to the system. To save or restore
announcements, an ANNOUNCEMENT Data Extension must be administered, and at least one
DATA-CHL (Network Control Data Channel) must be in the in-service/idle state.
Figure 23: Connection of announcement circuit pack to the system
MO Name in Alarm Log Alarm
level
Initial command to run Full name of MO
ANNOUNCE none none ANNOUNCEMENT
Switch Software Applications
Network Control
DATA
CHL1
DATA
CHL4
DATA
CHL3
Announcement
Circuit Pack
DATA
CHL2
Data-CHL
Software
Data-CHL
Software
Data-CHL
Software
Data-CHL
Software
PR-MAINT
CARD-MEM
TN798 Processor
TDM bus
cydmacps RPY 062397