Filter
Top Products
ANN-BD (Announcement circuit pack)
Issue 1 June 2005 461
Notes:
a. The Announcement circuit pack can exhibit a condition that does not allow recording.
If the circuit pack gets locked into this state (this is an extremely rare condition), two of the
Announcement Ports on the circuit pack will be unusable by software, one of which is the
record port. Also, save/restore announcements will not work since the record port
looks busy to the circuit pack. Note that software does not have any way of knowing this,
and attempts to use the ports.
If the circuit pack is locked into this state, the following symptoms are observed:
2007 ABRT The Announcement circuit pack thinks that Port 1 or Port 9 is busy.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, follow the Announcement Port
maintenance procedures for Ports 1 and 9.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
ABRT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1-3 FAIL Test failed. The error code indicates at which speech compression rate the
test actually failed (one being the first rate tested, three being the last).
1. Reset the circuit pack via reset board PCSS and then run this test
again. If the test still fails, replace the circuit pack (see Warning) and run
this test again.
2. If there are recurring alarms on this circuit pack caused by this test
failing, replace the circuit pack even if Step 1 works (see Warning).
!
WARNING:
WARNING: Replacing the circuit pack results in loss of integrated
announcements. See General notes
on page 465.
PASS The record channel on the Announcement circuit pack is functioning properly.
User-reported troubles on this circuit pack should be investigated using other
circuit pack and port tests. Refer to ANN-PT (announcement port)
on
page 465 for a description of the port tests.
Table 136: TEST #210 140AY loop around test (continued)
Error
code
Test
result
Description/ Recommendation
3 of 3