Communication Manager Maintenance-Object Repair Procedures
1634 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Misframe Alarm Inquiry Test (#145)
Misframe Alarm indicates that framing bits observed on an MM710 Interface Media Module are
in error. The Misframe Alarm Inquiry Test queries the total number of misframes that have
occurred on a DS1 Interface Media Module since the last inquiry.
When the DS1 Interface Media Module detects a misframe error, it increments its misframe
counter by one. If the counter reaches a specified threshold (i.e., 17), a MISFRAME-COUNT
message is automatically sent to the switch maintenance software. After the maintenance
software receives the MISFRAME-COUNT message, the Misframe Alarm Inquiry Test is
initiated to collect the misframe counts from the MM710 Interface Media Module.
Any NO
BOARD
The test could not relate the internal ID to the port (no board). This
could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Execute the add
ds1 location command to administer the MM710 interface if it
is not already administered.
2. If the board was already administered correctly, check the error log
to determine whether the board is hyperactive. If this is the case,
the board is shut down. Reseating the board will re-initialize the
board.
3. If the board was found to be correctly inserted in step 1, then enter
the busyout board location command.
4. Enter the reset board location command.
5. Enter the release board location command.
6. Enter the test board location long command.
This should re-establish the linkage between the internal ID and the
port.
Table 598: TEST #144 Slip Alarm Inquiry Test (continued)
Error
Code
Test
Result
Description/ Recommendation
4 of 4