Filter
Top Products
ATM-SGRP (ATM Signaling Group)
Issue 1 June 2005 609
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2500,
none
ABRT Internal system error or administration problem
1. Determine whether any B channels are administered.
2. If there are none, then this is a normal ABORT, since this test cannot
run unless at least one B channel is administered.
3. If at least one B channel is administered, there is an internal system
error. Retry the command at 1-minute intervals up to 5 times.
FAIL Internal system error
1. See description of ABORT with Error Code 2500.
PASS A message was sent to the far-end switch or terminal adapter. The ISDN
PRI specification allows up to 2 minutes for a reply.
1. Check the Error Log for ATM-SGRP errors of type 2305 for evidence of
a Remote Layer 3 Query failure.
2. If no new errors were logged since this test was run, then this switch
and the far-end switch can exchange call control messages.
3. If there is still a problem with a particular ATM trunk, busyout the trunk
and run the long test sequence, paying particular attention to the
results of Test #258 (ISDN test call).
Table 201: Test #1291 Remote Layer 3 Query (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2