Filter
Top Products
EXP-INTF (Expansion Interface Circuit Pack)
Issue 1 June 2005 1217
Expansion Interface Control Channel Test (#316)
This test is nondestructive. If an EI circuit pack is a standby EI circuit pack (amber LED off) or if
the EI is active in the PN (amber LED on), this test queries the EI circuit pack for its circuit pack
type and vintage information. If the EI circuit pack is an active EI circuit pack in the PN (amber
LED on long off short) the Expansion Interface Control Channel test checks to see if the EI
circuit pack can communicate with other circuit packs in the PN using the PN TDM bus.
0
NO
BOARD
No board was detected by the test.
1. Check the error log for wrong board (Error 125) or no board (Error 131).
Resolve either of these issues, if applicable.
2. Check that the board is properly translated and inserted. If so, check
for hyperactivity (Error 1538). If hyperactive, use reset board
location.
3. Run the test again. If it fails, the ID chip on board may be bad. Replace
the board and retest.
Table 413: Test #242 Expansion Interface Lightwave Transceiver Looparound (continued)
Error
Code
Test
Result
Description / Recommendation
6 of 6
Table 414: Test #316 Expansion Interface Control Channel Test
Error
Code
Test
Result
Description / Recommendation
2000 ABRT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABRT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1 of 2