Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
858 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Table 293: Test #844-848 Transmission Test
Error
Code
Test
Result
Description / Recommendation
1000 ABRT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Use display port location to determine the trunk group/member
number of the port. Use status trunk to determine the service
state of the port. If the port is active, wait until it is idle before testing.
2. If the port status is idle, then retry the command at 1-minute intervals
up to 5 times.
1001 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABRT The system could not allocate timeslots for the test. The system may be
under heavy traffic conditions or it may have timeslots out of service due to
TDM bus errors.
1. If the system has no TDM bus errors and is not handling heavy traffic,
retry the command at 1-minute intervals up to 5 times.
1004 ABRT The port has been seized by a user for a valid call. Use status trunk to
determine when the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1005 ABRT Trunk has been administered as incoming-only; transmission tests can only
be run on outgoing trunks.
1115 ABRT The near-end test line on the TN771 circuit pack could not be allocated.
1. Verify that the TN771 circuit pack is in service and that port 1 is
administered and in service with status port.
2. Retry the command at 1-minute intervals up to 5 times.
1900 ABRT The test completion message was not received from the TN771 circuit
pack.
1. Test the TN771 circuit packs.
1901 ABRT This error occurs when the TN771 circuit pack uplinks a message that is
not the proper response for this test. The anticipated uplink messages are
seize, ring or answer.
1. Verify that the trunk is administered properly.
1 of 4