Filter
Top Products
VAL-BD (Voice Announcements over LAN Circuit Pack)
Issue 1 June 2005 2497
Invalid LAPD Frame Error Counter Test (#597)
This test is nondestructive.
The VAL circuit pack detects invalid frames when it receives
● a frame with a CRC error.
● an unrecognizable frame.
● a recognizable frame in an unexpected state.
When the VAL circuit pack detects an invalid LAPD frame, it increments the Invalid LAPD Frame
error counter. This test reads and clears the counter, and verifies the repair of the problem.
Errors can indicate a:
● circuit pack problem.
● packet bus problem.
● problem with another circuit pack on the bus.
Table 884: Test #597 Invalid LAPD Frame Error Counter Test
Error
Code
Test
Result
Description / Recommendation
2000 ABRT Did not receive circuit pack test response within the allowable time period.
1. Retry command at 1-minute intervals up to 5 times.
2. If the problem persists, reset the circuit pack (reset board
location).
3. If the problem persists, replace the circuit pack.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
2500 ABRT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
1 of 2