Filter
Top Products
RANL-STA (Remote Analog Line (Station) Port)
Issue 1 June 2005 1923
1005 ABRT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
2000 ABRT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 FAIL This does not indicate a hardware problem. The switchhook audit failed.
The other updates were not performed because of this failure. This may
occur when the audit is performed at the same time the terminal equipment
goes off-hook. Use status station to determine when the port is
available.
1. Retry the command at 1-minute intervals up to 5 times.
5 FAIL This may be an internal software error. The message waiting lamp update
failed. The translation and ringer updates were not performed because of
this failure.
1. Retry the command at 1-minute intervals up to 5 times.
7 FAIL The translation update failed. There may be an internal software error. The
ringer update was not performed because of this failure.
1. Retry the command at 1-minute intervals up to 5 times.
8 FAIL This does not indicate a hardware problem. There may be an internal
software error. The ringer update failed.
1. Retry the command at 1-minute intervals up to 5 times.
PASS The software and the port processor have the same status. User-reported
troubles on this port should be investigated by using other port tests, by
examining station wiring, or by examining the station.
Table 706: Test #36 Station Status and Translation Audits and Updates (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2