Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
2454 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
2000 ABRT Response to the test was not received within the allowable time period.
This may be due to hyperactivity. Error Type 1538 in the error log
indicates hyperactivity. The hyperactive circuit pack is out of service, and
one or more of the following symptoms may be exhibited.
1. The UDS1-BD tests (such as Tests #138 and #139) are aborting with
Error Code 2000.
2. The tests run on the ports of this circuit pack are returning a no-board
result.
3. A busyout or a release command has no effect on the test results.
4. A list config shows that the circuit pack and its ports are properly
installed.
When hyperactivity occurs, the circuit pack is isolated from the system, and
all of its trunks are placed into the out-of-service state. The system will try
to restore the circuit pack within 15 minutes. When no faults are detected
for 15 minutes, the UDS1 interface circuit pack is restored to normal
operation. Every UDS1 Interface trunk is then returned to the in-service
state. Hyperactivity is often caused by the associated facility. In such a
case, faults (such as slips, misframes, or blue alarms) would be entered in
the error log. In addition, many hardware errors would be logged against
the associated trunk circuits. If the facility is OK and the error occurs again
after 15 minutes, replace the circuit pack.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL UDS1 Interface circuit pack failed the CSU Repeater Loopback test.
1. Retry test ds1-loop location ds1/csu-loopback-tests
2. If the RLB test continues to fail, and the CSU Equipment Loopback
test (#1210) passed, then replace the CSU module/T1 sync splitter.
PASS The RLB test executed successfully. The test pattern was transmitted and
received successfully over the connection from the UDS1 board to the
far-edge of the 120A1 CSU module or the 401A T1 sync splitter.
Table 869: Test #1211 CSU Repeater Loop-Back Test (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 4