Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
2276 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Table 815: Test #6 NPE Crosstalk Test
Error
Code
Test
Result
Description / Recommendation
ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABRT System resources required to run this test were not available.
The port may be busy with a valid call.
1. Use display port location to determine the trunk
group/member number of the port. Use status trunk to
determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable
for certain tests. Wait until the port is idle before retesting.
2. If the port status is active but the port is idle (no calls),
check the error log for Error Type 1025 (see the error log
table for a description of this error and required actions).
The port may be locked up.
3. If the port status is idle, retry the command at 1-minute
intervals up to 5 times.
1001 ABRT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABRT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions, or it may have
time slots out of service due to TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling
heavy traffic and the port status is idle, retry the command
at 1-minute intervals up to 5 times.
1003 ABRT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of tone detectors
present or some of the tone detectors may be out of service.
Enter list measurements tone-receiver to display
basic information about the system's tone receivers.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute
intervals up to 5 times.
1 of 3