Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
552 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
40MM FAIL Failure code only applies to a system equipped with an ATM Switch. The
letters “MM” refer to the distant or far-end PN, and “NN” to the near-end
ATM-EI under test.
The test failed for the first connection from the ATM-EI board under test to
another PN, and the test tone was detected correctly in the reverse
direction (data sent from port network MM was detected correctly in the PN
where the circuit pack under test resides), but not the opposite direction.
1. Test for the Active Tone-Clocks on port network MM and the PN where
the ATM-EI under test resides. This determines if dial tone is
supplied.
2. Ensure that the ATM address of the active ATM-EI circuit pack in port
network MM matches the ATM address on the ATM switch for the port
to which this circuit pack is connected. Refer to ATM Installation,
Upgrades, and Administration using Avaya Communication Manager,
555-233-124, for the procedure to check the ATM port address on the
ATM switch.
3. Run Test #241 on the active ATM-EI in port network MM. If this test
fails with Error Code 20NN or 40NN, go back to step 2.
If the address was the same, replace the active ATM-EI circuit pack on
port network MM.
If this test fails with Error Code 10NN or 30NN, replace ATM-EI circuit
pack with the initial problem.
PASS Tone successfully transmitted in both directions. Both ATM-EI boards and
their lightwave transceivers are functioning properly.
0
NO
BOARD
No board was detected by the test.
1. Resolve either wrong board (Error 125) or no board (Error 131)
issues.
2. Check that the board is properly translated and inserted. If so, check
for hyperactivity (Error 1538). If hyperactive, use reset board
location.
3. Run the test again. If it fails, the ID chip on board could be bad.
Replace the board and retest.
Table 174: Expansion Interface 2-Way Transmission Test (#241) (continued)
Error
Code
Test
Result
Description / Recommendation
8 of 8