Filter
Top Products
ATM-EI (Expansion Interface Circuit Pack)
Issue 1 June 2005 567
None ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort escalate the problem.
2000 ABRT Did not receive the SANITY response in the given time.
1. Wait for 5 minutes and see if board is visible to the system by using
list config all.
2. If the board is visible, run the test again. If same abort code results,
escalate the problem.
3. If the board is not visible to the system with list configuration
all, reseat the board.
4. If the board is still not recognized by the system, replace the board.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2500 ABRT Internal system error
1. Try to reset the board again.
1 FAIL The circuit pack failed to reset.
2 FAIL The circuit pack failed to restart.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
PASS The ATM-EI circuit pack is successfully reset.
1. If status port-network still indicates that this link is down, it is
possible that one or both of the ATM-EI circuit packs are busied out.
2. If the links do not come up after reset, review the error logs and take
appropriate diagnostic action.
Table 183: ATM Board Reset (#1256) (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2