Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
1740 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
2000 ABRT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test aborts with Error Code 2000 again, run short test
sequence on the associated DS1-BD or UDS1-BD. If tests 138
through 145 on the associated DS1-BD or UDS1-BD are also
aborting with Error Code 2000, hyperactivity on the board or facility
is indicated. In this case, the hyperactivity problem should be dealt
with first.
2100 ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The test failed. This can be due to on-board or off-board problems.
Off-board problems of concern include EXP-PN, EXP-INTF, or
RMC-ENV faults, TDM-BUS faults, and faults associated with the tone
detectors/tone generators. Clear every off-board problem before
replacing the board. Keep in mind that a TDM-BUS problem is usually
the result of a faulty board connected to the backplane or bent pins on
the backplane.
1. Resolve any TONE-BD and/or TONE-PT errors.
2. Retest when the faults from step 1 are cleared.
PASS The port is correctly using its allocated time slots. User-reported troubles
on this port should be investigated using other port tests and by
examining station, trunk, or external wiring.
Table 644: Test #6 NPE Crosstalk Test (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 4