Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
1270 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
109 FAIL The SNI circuit pack (Endpoint 1) cannot communicate with the equipped
SNI in slot 9. Use list fiber-link to see a fiber link’s endpoints.
1. Perform the Fiber link fault isolation
in Chapter 4: General
troubleshooting in Maintenance Procedures (03-300192). This should
resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER Error Type 1793, replace the
SNI being tested. (Replacing an SNI may be service interrupting.
Refer to the SNI-BD section for the procedure to replace an SNI.) To
view SNI-PEER errors, use display errors with category
PNC-PEER. Retry the command.
3. If the SNI being tested still has SNI-PEER Error Type 1793, replace
the SNI in slot 9.
112 FAIL The SNI circuit pack (Endpoint 1) cannot communicate with the active
SNC. Use list fiber-link to see a fiber link’s endpoints.
1. Check the error log for other SNI circuit packs in the same carrier with
a 257 SNI-BD error. Use display errors with category PNC to
view SNI-BD errors. If other SNI circuit packs in the same switch node
carrier have Error 257, then replace the active SNC in this switch node
carrier. Replacing an SNC may be service interrupting. Refer to the
SNC-BD section for the procedure for replacing an SNC.
2. Replace this SNI.
3. Replace the active SNC in the same switch node carrier.
113 FAIL The SNI circuit pack (Endpoint 1) cannot communicate with the equipped
SNI in slot 13. Use list fiber-link to see a fiber link’s endpoints.
1. Perform the Fiber link fault isolation
in Chapter 4: General
troubleshooting in Maintenance Procedures (03-300192). This should
resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER Error Type 2049, replace the
SNI being tested. (Replacing an SNI may be service interrupting.
Refer to the SNI-BD section for the procedure to replace an SNI.) To
view SNI-PEER errors, use display errors with category
PNC-PEER. Retry the command.
3. If the SNI being tested still has SNI-PEER Error Type 2049, replace
the SNI in slot 13.
Table 440: Test #759 Configuration Audit (continued)
Error
Code
Test
Result
Description / Recommendation
6 of 22