Filter
Top Products
MEDPRO (Media Processor MAPD Circuit Pack)
Issue 1 June 2005 1545
Table 566: Test #53 SAKI Sanity Test
Error
Code
Test
Result
Description / Recommendation
None ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1015 ABRT Port is not out-of-service.
1. Busyout the circuit pack.
2. Execute command again.
2100 ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2803 ABRT It is necessary to reset the board.
1. Use change ipserver-interfaces to disable the Media
Processor IP interface.
2. Execute the command again.
1 FAIL The circuit pack failed to reset.
2 FAIL The circuit pack failed to restart.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
PASS The circuit pack initializes correctly.
1. Run the short test sequence.
Any NO
BOARD
This is normal if the test is being done when the board is not physically
in the system or when the system is booting up. Otherwise, there is
some inconsistency between the physical configuration and the data
kept in the system.
1. Verify that the board is physically in the system.
2. Verify that the system is not in a stage of booting up.
3. Retry the command at 1-minute intervals up to 5 times.