Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
492 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Signaling Link Status Test (#626)
This test determines the current status of the signaling link. This test passes if the link is
“bound” to an endpoint and fails if the link is “not bound.”
The definition of the term “bound” for a link depends upon the type of endpoint and may depend
on the successful completion of procedures at both Layers 2 and 3 of the protocol. The
definition of “bound” for ASAI type of endpoint is:
● ASAI adjuncts and BRI endpoints not administered for MIM initialization (point-to-point):
For endpoints of this type, the signaling link is “bound” when the link is connected at Layer 2
(L2 established).
Table 148: Test #626 Signaling Link Status Test
Error
Code
Test
Result
Description / Recommendation
1139 ABRT The PN’s packet bus is out-of-service.
1. Follow the repair procedures for the packet bus.
2. After completing step 1, execute test port location long and
review the results of the BRI Port Local LAN Looparound test (#618) to
verify the repair.
1141 ABRT The PKT-CTRL is out-of-service.
1. Refer to PKT-CTRL maintenance documentation.
S8700
| 8710
S8500:
1187
ABRT The circuit pack, port, or station may have been busied out.
1. Look in the Error Log for Error Type 18 (busied out) for ASAI-BD,
ASAI-PT, or ASAI-EPT.
2. If this Error Type is present for ASAI-EPT only, use release
station and run the test again.
3. If this Error Type is present for ASAI-PT and ASAI-EPT, use release
port and run the test again.
4. If this Error Type is present for ASAI-BD, ASAI-PT, and ASAI-EPT, use
release board and run the test again.
2012 ABRT Internal system error
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 2