Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
366 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
NPE Crosstalk Test (#6)
This test verifies that this port’s NPE channel talks on the selected time slot and never crosses
over to time slots reserved for other connections. If the NPE is not working correctly, one-way
and noisy connections may be observed. This test is part of the long test sequence and
executes in about 25 seconds.
Table 100: Test #6 NPE Crosstalk Test
Error
Code
Test
Result
Description / Recommendation
ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABRT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Use display port location to determine the station extension.
Use status station to determine the service state of the port. If the
port is active, it is unavailable for certain tests. Wait until the port is idle
before testing.
2. Retry the command at 1-minute intervals up to 5 times.
1001 ABRT Could not allocate the necessary system resources to run this test.
1002 ABRT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
then retry the command at 1-minute intervals up to 5 times.
1003 ABRT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present, or some Tone
Detectors may be out of service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. Retry the command at 1-minute intervals up to 5 times.
1 of 2