Filter
Top Products
MG-IAMM (Integrated Analog Media Module)
Issue 1 June 2005 1647
Ringing Application Test (#51)
This test is not applicable to media modules and will always abort.
Control Channel Loop Test (#52)
This test has two parts. Part one of the test, which is not run on media modules, sends Control
Channel Message Set (CCMS) downlink messages to notify the Media Module which TDM bus
the Control Channel is on and which TDM bus the touch tones are on.
The second part of this test sends board vintage and type inquiries to the media module and
checks the associated responses.
Table 604: Test #51 Ringing Application Test
Error
Code
Test
Result
Description / Recommendation
1412 ABRT 1. This test is not run on media modules and will always abort.
Table 605: Test #52 Control Channel Loop Test
Error
Code
Test
Result
Description / Recommendation
None
2100
ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The test failed because the media module failed to return the code or
vintage.
1. Retry the command up to 5 times.
2. If the test still fails, enter:
● busyout board location
● reset board location
● release board location
and then retest.
3. If the problem continues, replace the media gateway.
4. Run the test again.
PASS Communication with this circuit pack or media module is successful.