Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
888 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Notes:
a. Error Type 0
: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its recommended procedures.
b. Error Type 1: DS1 Interface circuit pack or media module detects a hardware error on the
DS1 DID trunk. The Aux Data field indicates the following:
Maintenance does not start any testing or generate any alarms in response to these errors.
c. Error Type 15 is a software audit error that does not indicate hardware malfunction. Run
short test sequence, and investigate any errors.
d. Error Type 18: The trunk has been taken out of service by a demand busyout. No calls can
be made on this trunk.
e. Error Type 130 indicates that the circuit pack or media module has been removed or has
been insane for more than 11 minutes. To clear the error, reinsert or replace the circuit pack
or media module.
f. Error Type 257: DS1 Interface circuit pack or media module detects a hardware error on
the DS1 DID trunk. The Aux Data field indicate the source of the error:
g. Error Type 513: DS1 Interface circuit pack or media module detects a hardware error on
the DS1 DID trunk. Aux Data 57392 indicates no external release on PBX disconnect.
h. Error Type 769: DS1 Interface circuit pack or media module detects a hardware error on
the DS1 DID trunk. Aux Data 57393 indicates belated external release on PBX disconnect.
i. Error Type 1793: DS1 Interface circuit pack or media module is out-of-service. Look in the
Hardware Error Log:
57476 On-hook before wink
57477 On-hook before ready to receive digits
57485 Wink too short for valid signal
57474 Rotary dial rate above 12 pulses per
second
57473 Rotary dial rate below 8 pulses per
second
If port is on Look in
TN767 DS1 Board DS1-BD
TN464 UDS1 Board UDS1-BD
S8300 / G700: MM710 DS1 Media Module MG-DS1