Filter
Top Products
UDS1-BD (UDS1 Interface Circuit Pack)
Issue 1 June 2005 2397
aa. Error Type 3842: bad translation RAM location found error. This error is not
service-affecting. No action is required. A Bad Translation RAM is detected, but the call
continues by using another translation location.
ab. Error Type 3843: LAN Receive Parity Error. This error occurs when the circuit pack detects
an error in a received frame from the Packet bus. These errors are most likely caused by a
Packet bus problem, but may be due to a circuit pack fault.
See PKT-INT (Packet Interface)
on page 1799 to determine whether the problem is isolated
to this circuit pack or is caused by Packet bus faults.
ac. Error Type 3900: provides status information about a CPE Loop-Back Jack test. The value
in the Aux Data field indicates the status of the loop-back test.
ad. Error Type 3901: provides status information about a Far CSU Loopback test. The value in
the Aux Data field indicates the status of the loop-back test.
ae. Error Type 3902: provides status information about a One-Way Span test. The value in the
Aux Data field indicates the status of the span test.
Aux Data Test Status
1 Test is currently running
2 Failed because loop back could not be activated
3 Failed because test pattern could not be detected
4 Test has been terminated
Aux Data Test Status
1 Test is currently running
2 Failed because loop back could not be activated
3 Failed because test pattern could not be detected
4 Test has been terminated
Aux Data Test Status
1 Test is currently running
2 Failed because test could not be activated
3 Test pattern was not received from the far end
4 Test has been terminated