Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
2500 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
2012 ABRT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
2100 ABRT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
1 FAIL The buffer level is nearly exhausted.
2 FAIL The VAL is congested, and no buffers are available.
1. Retry command at 1-minute intervals up to 5 times.
2. If command continues to fail, examine the VAL port measurements to
determine which ports are heavily utilized and the processor
occupancy of the circuit pack.
A Low processor occupancy when VAL is congested indicates circuit pack
failure.
1. If the problem persists, reset the circuit pack (reset board
location).
2. If congestion recurs, replace the circuit pack.
High processor occupancy indicates the VAL is congested due to traffic
load.
To relieve congestion in the short term, selectively busyout ports
(busyout port location) on the VAL circuit pack.
To achieve a more permanent resolution, it could be necessary
reassign announcements to other integrated announcement circuit
packs.
Consider replacing affected VAL ports with new ports.
3 FAIL The VAL circuit pack is not operating normally and is congested.
PASS Hardware setting and attached cable type match VAL circuit pack
administration. The circuit pack detects no errors.
Table 886: Test #600 Congestion Query Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2