ANN-BD (Announcement circuit pack)
Issue 1 June 2005 455
Announcement checksum test (#209)
Associated with every recorded announcement is a checksum. In this test, the SP checks a
stored global checksum covering all recorded announcements against a calculated one and
returns the results to the maintenance system. If the global checksum failed, maintenance
requests the SP to check each individual announcement’s checksum.
Table 134: TEST #208 angel-speech processor (SP) handshake test
Error
code
Test
result
Description/ Recommendation
2000 ABRT Response to the test request was not received within the allowable time
period. If Error Type 1538 is present in the Error Log, follow the maintenance
strategy recommended for this Error Type.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
ABRT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL Test failed. Circuit pack cannot be used. Announcement speech memory is
cleared when this test fails. Therefore, when the problem has been resolved,
announcements must be rerecorded or downloaded to the circuit pack.
1. Reset the circuit pack via reset board PCSS and then run this test
again. If the test continues to fail, replace the circuit pack and then run
this test again.
2. If there are recurring alarms on this circuit pack caused by this test
failing, replace the circuit pack even if Step 1 works.
!
WARNING:
WARNING: Replacing the circuit pack results in loss of integrated
announcements. See General notes
on page 465.
PASS The communications link between the two processors on the Announcement
circuit pack is functioning properly. User-reported troubles on this circuit pack
should be investigated using other circuit pack and port tests. Refer to
ANN-PT (announcement port)
on page 465 for a description of the port tests.